September 2008
Task: Prep Outer Ankles for paint

September 2008
I want to drill a hole for a rubber grommet
This is what I'll pass the motor wires through
Because the wires will go into my Battery Box I drilled the hole on the backside of the Outer Ankle

September 2008
Using a Multidiameter Step drill I made the appropriate size hole
Did a fit check. Had to make the hole a little larger and then did another fit check, Perfect
Other than that my JAG Outer Ankles are ready for paint

September 2008
Rubber Grommet I found at my local hardware store

NEXT PAGE