September 2008
Position the JAG steel NPC Motor Mount onto the inside Outer Foot Channel
I centered mine

September 2008
Mark the four or six mounting hole positions

September 2008
Using a nice sharp 9/32" drill bit, drill out the holes
These are clearance holes for 1/4"-20 screws

September 2008
I typically go back and clean up the holes with a countersink bit
Just to break the sharp edge and get rid of any debree

September 2008
I like to have handles at the rear of my Outer Feet
These have been very helpful during transportation of the Droid
It gives you something to get a good lifting grip on
Position them and drill the required holes

September 2008
These particular handles use a #10-32UNF Screw
So I used a 7/32" diameter drill bit
Later I'll attach these with screws, lockwashers and loc-tite for final assembly

September 2008
Knurled Hose Fittings

September 2008
Outer Foot Front Strips

September 2008
Handles

NEXT PAGE