Mounting Bracket
Using the screws provided mount the Lifter Assembly
to the mounting bracket using the following hardware:
Quantity 4, Slot Head Screw
Quantity 4, Flat Washers
Quantity 4, Hex Locknuts

Mounting Bracket
I let the Lifter Assembly sit as far down as possible
Then tightened all screws
This might need adjusting at final install

Wire Connections
(LEFT TO RIGHT)
Terminal #1 = Ma (Motor)
Terminal #2 = * Empty
Terminal #3 = Mb (Motor)
Terminal #4 = S (Spare/Extra)
Terminal #5 = R (Spare/Extra)
Terminal #6 = B (Spare/Extra)

Wired
Testing the Periscope Lifter before I install it.

Wired
"Vantec" RET 411 Motor Controller
ORANGE WIRE = POSITIVE +
BLACK WIRE = NEGATIVE -
WHITE WIRE = MOTOR
GREY WIRE = MOTOR

Wired
12 Volt Battery Power Supply
I used a 3 AMP, Re-Setable, Push Button Circuit Breaker in the Power Supply Line for safety.
PUSH BUTTON CIRCUIT BREAKERS
These are great to use! No More fuses to change!

Wired

Wired
Motor Controller plugged into Slot #7 of the
"Futaba" 7 channel receiver.
This lets you use a two position toggle switch on your Remote
Flip the toggle up and the periscope rises
Flip the toggle down and the periscope lowers
If yours operates backwards, reverse the Grey and White wire connections

Periscope - UP

Periscope - UP

Periscope - UP